MATLAB XPC TARGET 4 - DEVICE DRIVERS Spezifikationen PDF herunterladen (Seite 219)

100

101

PCL-818

7-19

enter numbers between 1 and 8. For example, to use the first and second analog

output (A/D) channels, enter

[1,2]

Number the channels beginning with 1 even if the board manufacture starts

numbering the channels with 0.

Range Vector - Enter a range code for each of the channels in the channel

vector. The range vector must be the same length as the channel vector. This

board allows the range of each channel to be different.

The following table is a list of the ranges for this driver and the corresponding

range codes.

For example, if the first channel is -10 to +10 volts, and the second channel is

0 to 5 volts, enter

[-10,5]

The range settings have to correspond to the DIP-switch settings on the board.

MUX - From the list, choose either single-ended(16 channels) or

differential (8 channels). Your choice must correspond to the MUX-switch

setting on the board.

Sampletime - Base sample time or a multiple of the base sample time.

BaseAddress - Enter the base address of the board. It is important that this

entry corresponds to the DIP-switch settings on the board. For example, if the

base address is 300 (hexadecimal), enter

0x300

Input range (V) Range code Input range (V) Range code

-10 to +10 -10 0 to 10 10

-5 to +5 -5 0 to +5 5

-2.5 to +2.5 -2.5 0 to +2.5 2.5

-1.25 to +1.25 -1.25 0 to +1.25 1.25

-.625 to +.625 -0.625

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 652 653

Kommentare zu diesen Handbüchern

Keine Kommentare

MATLAB XPC TARGET 4 - DEVICE DRIVERS Spezifikationen Seite 219

Kommentare zu diesen Handbüchern