MATLAB SIMEVENTS RELEASE NOTES Betriebsanweisung PDF herunterladen (Seite 13)

Related Products

In this section...

“Information About Related Products” on page 1-5

“Limitations on Usage with Related Products” on page 1-5

Information About Related Products

For information about related products, see http://www.mathworks.com/products/

simevents/related.html.

Limitations on Usage with Related Products

Code Generation

SimEvents blocks do not support code generation using the Simulink Coder™ product

in version 4.0 (R2011b). In previous versions up until version 3.1.2 (R2010a), SimEvents

blocks offered limited code generation support for rapid simulation. This support will

no longer be available for models upgraded to use the new SimEvents syntax in version

4.0 through the seupdate model update process. Support for rapid simulation has

been removed because the improvements in normal model simulation performance for

SimEvents models match or surpass the performance of rapid simulation in releases

prior to version 4.0.

Simulation Modes

SimEvents blocks do not support simulation using the Rapid Accelerator, Accelerator,

Processor-in-the-Loop (PIL), or External mode.

Model Reference

SimEvents blocks cannot be in a model that you reference through the Model block.

Function-Call Split Block

SimEvents blocks cannot connect to the Function-Call Split block. Instead, to split a

function-call signal that invokes or originates from a SimEvents block, use the Signal-

Based Event to Function-Call Event block as in “Issue Two Function Calls in Sequence”

in the SimEvents user guide documentation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 113 114

Keine Kommentare

MATLAB SIMEVENTS RELEASE NOTES Betriebsanweisung Seite 13